Cleaning The Device; Cautions For Use - Num'axes EYENIMAL Digital Pet Clipper Manual De Instrucciones

Cleaning the device

Clean the device every time you have used it. Clean the blades and combs by blowing on them or using
the cleaning brush provided.
Clean your device regularly with a slightly damp, soft cloth.
After cleaning the blades, put a little drop of oil between the 2 blades to lubricate them for next use.
Remove the comb by following the instructions of the figure below.
How to groom your pet
Dirt and sand in pet's hair can damage the blades. Therefore, we recommend to bath and blow dry
carefully, if necessary also untangle your pet's hair before grooming.
Acclimate your pet to the clipper sound, by approaching the clipper from him while speaking your pet in
a soft, soothing voice, petting and cuddling him.
Start by clipping from the face and throat, then the neck, shoulder area. Run to the back, backside, sides
and belly. Continue to the chest, and finish by the legs (it's easier to clip the legs hold in straight position)
Place the blade safely against the pet's body, and clip slowly in the direction of hair growth, be careful
to still place the blade alongside the skin. Make successive lines, try as possible to end the line, avoid
clipping the same area several times.
Face and throat must be clip against hair's growth.
To clip paws, place the blade at the beginning of the nail, and run slowly against hair's growth along
each toe. Be careful not cutting between the toes.

Cautions for use

1. Do not disassemble the clipper yourself.
2. Do not clean the clipper with tap water and leave the mower away from moisture.
3. Do not use corrosive products such as alcohol or gasoline to clean the clipper.
4. Keep the clipper away from heat source. It should be stored in a cool and dry environment.
10