Skytec STC-55 Manual De Instrucciones página 3

14.USB PORT
Allows the connection of any USB memory stick.
15. 3 IN 1 CARD SLOT
Slot for inserting 3 IN 1 card. The contacts of the card must point downwards. The unit cannot read cards with a
capacity of more than 4GB. The unit is not compatible to SDHC cards and only supports the MP3 format.
16.USB/SD
To select audio source between USB storage and SD card.
17.PITCH BUTTON
Pitch on/off switch. the adjustment of the pitch potentiometer is available when at pitch on state and the light is
illuminate.
18. INPUT TOGGLE SWITCH – (USB-SD / USB B / Phono-Line)
Selects which source will be live to that channel based on what you have connected to the rear panel input section. In
USB1 or USB or SD1 position the internal USB2 or USB or SD2 units are active
19.CUE FOR CH1-2
Selects which source will be live to that channel for CH1 &CH2
20. INPUT TOGGLE SWITCH – (USB-SD / USB B / Phono-Line)
Selects which source will be live to that channel based on what you have connected to the rear panel input section. In
USB2 or USB or SD2 position the internal USB1 or USB or SD1 units are active
21.DISPLAY
LCD Display Indicate the Track/Numbers//Time/Remain/Pitch/Continue/Single.
22.1N BUTTON《LOOP SYSTEM)
This button sets the beginning point of the loop and the light is illuminate.
23.OUT BUTTON《LOOP BUTTON)
When you press this button, you set the end point of the seamless loop and you start the loop. To finish the loop, press
again this button.
24.RELOOP BUTTON(LOOP SYSTEM)
This button is used to start the last saved loop. To finish the loop, press the reloop button.
25.DSP/REVERSE
Push the reverse button to play your track in reverse,push the reverse button again to cancel this feature.
26.DSP/BRAKE
In play mode.you push the brake buttion at frist,and then push play/pause button,the operation changs is slowness from
play to pause, push play/pause button again to cancel this feature.
27.SINGLE
Press these to switch between the SINGLE and CONTINUE play mode. The selected mode is indicated on the LCD. In
SINGLE mode, after each track, the unit stops the reading. In CONTINUOUS mode, the unit read all track and stops.
28. TIME BUTTON
Used this knob to choose the time mode:Elapsed time, remaining time or total remaining time.
29.REPEAT BUTTON
Use this button to repeat one track or all the track of the CD
30.ID3
When you pressing the ID3 button,Able to show the name of songs on led display.
31. PITCH CONTROL
Use this fader to increase or decrease the speed of the track. Slide up to decrease the pitch and slide down to increase
the pitch.