Unpacking And Inspecting Of The Hinged Cantilever For Extraction Arm 6.0 - 10 M; Assembly Requirements; Recommended Mounting Material; Mounting Material For Mounting On Walls - Kemper 1502199 Instrucciones De Montaje

1.2 Unpacking and Inspecting of the Hinged Cantilever for the
Extraction Arm 6.0 - 10 m
1.3

Assembly Requirements

1.4

Recommended Mounting Material

6 M12 130 100
7 M12 130 100
8 M12 130 100
9 M12 130 100
10 M12 130 100
Art. Nr.: 1502199
General Assembly
● Remove the packaging carefully.
● Check if delivery is complete. Use the delivery sheet.
● If any parts are missing or have been incorrectly delivered,
please immediately contact Kemper GmbH or the supplier.
WARNING
Risk of injury due to falling components!
Components that are not adequately attached could detach and
cause serious
injuries!
● For the mounting on walls, use only suitable
mounting material
● Mount the hinged cantilever for the extraction arm
6.0 - 10 m on suitable walls.
● Observe the tightening torques of the screws
● Only use supplied mounting material

Mounting Material for Mounting on Walls

Fischer dowel Highbond anchor
Fischer dowel Highbond anchor
Fischer dowel Highbond anchor
Fischer dowel Highbond anchor
Fischer dowel Highbond anchor
FHB dyn 40
12x100/25
FHB dyn 40
12x100/25
FHB dyn 40
12x100/25
FHB dyn 40
12x100/25
FHB dyn 40
12x100/25
Reinforced 450
concrete C25/30
Reinforced 450
concrete C25/30
Reinforced 450
concrete C25/30
Reinforced 470
concrete C25/30
Reinforced 470
concrete C25/30
200
200
200
200
200
1-2