Two graduated scales (1 by output) indicate you 64 power levels.
You also fi nd 6 order keys (scheme, page 10) :
- 1 ON/OFF "O" - a short press
- 1 "P" to select the programs - a short press
- 2 "+/-" keys per output, in each side of the LCD display, to adjust the intensity of the stimulation.
A long (1 sec.) press on the "-" key allows to return the power level rapidly to zero.
FUNCTION 1 - "ON / OFF" SWITCH
• A short press on the "O" key puts the device under or off power.
• Every time under power, the device makes an auto-test on 11 essential parameters at the level of the safety of its operation.
During the auto-test segments and pictograms are lit during 0,5 second.
• If an internal defect in the device is detected, all the pictograms fl ash. Send back the device to the After Sale Service.
• The auto-test does not take into consideration the used batteries. When the batteries are used the autotest cannot be performed.
• One long press (over 3 sec) on the "O" key stirs up the auto-test.
In this case, stop the device by pressing the "O" key and then press shortly the "O" key again.
FUNCTION 2 - CHOICE OF A PROGRAM "P"
Just make one or several presses on the "P" key, the programs ravel.
The programs are announced by numbers from 1 to 4.
Once the program is chosen, the program number is shown on the display. (see page 10).
Once the program is chosen, you can start it by increasing only one of the both "+"keys.
During the program the "P" key is inactive.
FUNCTION 3- END OF PROGRAM - STOP
• At the end of the program the device stops automatically.
• To stop the device during a program, you just have to turn 2 power keys to zero or to press the "O" key.
• In case of emergency, press the "O" key.
FUNCTION 4 - ADJUSTMENT THE POWER
You have 64 levels from 0 to 64 to adjust the electro-stimulation power.
Between two segments, there are 7 power levels or 4 short press on "+" key.
FUNCTION 5 - BATTERIES
• If the batteries are "good", there is no blinking.
• If the batteries are "weak", two segments (the 6th segment) blink (scheme page 10). Your device still works.
• If the batteries are "used", two segments (the 10th segment) blink (scheme page 10).
• If your device stops, even during a program: change the batteries.
FUNCTION 6 - DISCONNECTION
Your device is endowed with an accessory disconnecting detector.
If there is no contact between the skin and the accessory, the power is stopped on the concerned output (channel A or B).
You are warned of the disconnection by blinking of the 1
If no accessory is in contact with the body, the power cannot be emitted.
III. CONTACT CREAM
The SPORT-ELEC® cream is used with accessory.
It also may be used for a manual massage of the body as well.
The cream facilitates the contact between electrodes and skin.
Its massaging and electroconducting properties improve comfort and effi ciency of the stimulation.
If you wish to buy again some cream, order it directly at 02 32 96 50 50, on our website www.sport-elec.co.uk, or contact your local
retailer.
WARNING
• You must not use the belt without having ap-
plied the cream on the built-in electrodes.
• Do not use any other cream except the one
supplied by SPORT ELEC ®Institut
12
st
segment during 30 sec., after 30 sec. the blinking stops (diagram, page 10).
SAFETY PRECAUTIONS BY USING THE CREAM
• In case of allergy, stop to apply the cream.
• Do not swallow.
• Do not leave with the range children.
• In case of contact with eyes rinse with water.