Dräger X-am 5600 Instrucciones De Uso página 12

 Press the [OK] key to start the channel selection.
In the case of the CO channel there is a 2-stage calibration routine:
2
The zero calibration takes place first and is then followed by the span calibration.
– The display shows the gas of the first measuring channel, e.g. » CH
 Press the [OK] key to start the adjustment function of this measuring channel,
or use the [ + ] key to select another measuring channel (O
CO - ppm, etc.).
– The test gas concentration is displayed.
 Press the [ OK ] key to confirm the test gas concentration or use the [ + ] key
to change the test gas concentration and complete the process by pressing
the [ OK ] key.
– The measurement value flashes.
 Open the test gas cylinder valve to let gas flow over the sensor with a
volume flow of 0.5 l/min.
– The displayed, flashing measurement value changes to the value according
to the supplied test gas.
When the displayed measurement value is stable (after at least 120 seconds):
 Press the [ OK ] key to perform the adjustment.
– The display containing the current gas concentration changes with the
display » OK «.
 Press the [ OK ] key or wait for approx. 5 seconds to end the adjustment of
this measuring channel.
– The next measuring channel is displayed for adjustment if necessary.
– After the adjustment of the last measuring channel, the instrument changes
to the measuring mode.
 Close the test gas cylinder valve and remove the instrument from the
calibration cradle.
If a fault has occurred during the span calibration:
– The fault message » « appears and »
respective sensor instead of the measured value.
 In this case, repeat the calibration.
 Change the sensor if necessary.
12
NOTICE
- Vol.-%, H
2 2
« is displayed for the
Cleaning
The instrument does not need any special care.
 Dirt and deposits can be removed from the instrument by washing it with
cold water. A sponge can be used for wiping if necessary.
LEL «.
4
Abrasive cleaning tools (brushes etc.), cleaning agents and cleaning solvents
S - ppm,
can destroy the dust and water filters.
 Carefully dry the instrument with a cloth.
Maintenance
The instrument should be inspected and serviced once a year by suitably
qualified persons. Comparisons:
 EN 60079-29-2 – Gas detectors - Selection, installation, use and
maintenance of detectors for flammable gases and oxygen
 EN 45544-4 – Electrical apparatus used for the direct detection and direct
concentration measurement of toxic gases and vapours - Part 4: Guide for
selection, installation, use and maintenance
 National regulations
Recommended calibration interval for measuring channels O
NO and CO: 6 months.
2
Recommended calibration intervals for the measuring channel IR Ex/CO
12 months.
Calibration intervals of other gases: see Instructions for Use of the respective
DrägerSensors.
See the Technical Manual for details of spare parts.
Storage
 Dräger recommends storing the instrument in the charger module
(order no. 83 18 639).
 Dräger recommends checking the charge of the power supply at least every
three weeks if the instrument is not stored in the charger module.
CAUTION
, H S, H , SO
2 2 2
,
2
:
2