BH HI POWER SK Serie Instrucciones De Montaje Y Utilización página 69

5) STEADY PULSE RATE TIME.-
With the word "SPR time" flashing, press the ENTER key and a figure between 20 and 60 seconds will start
flashing. Select the flashing value using the SPEED
the word "SPR time" will start flashing again, using the SPEED
If you wish to exit the personalisation mode press the STOP key.
Setting
Define the language in which messages are displayed on the monitor.
1) Language
Options: Spanish, Portuguese, English, French, German, Dutch, Italian.
Enables or disables sound messages emitted by the monitor.
2) Sounds Options: - ON
Options: - OFF (The welcome message is displayed by default)
3) Text
For personalising the welcome message, including, for example, the name of the
gymnasium.
Establishes a maximum time limit for the exercise.
4) Manual T Options: - 0 (No maximum time limit established)
Establishes the calculation rate for the steady pulse rate program.
5) SPR time
Options: Value in seconds (minimum 20, maximum 60)
CHANGING FROM km to Miles.-
To change from km to miles press the ENTER key for 10 seconds, this will take you to the change option,
displaying "KM" on screen (B). Use the INCLINE▲ and INCLINE ▼ keys to select the speed measure scale
(METRIC / km. -- IMPERIAL / Miles) and press the ENTER key.
ELEMENTS OF THE ELECTRONIC MONITOR (Fig.1).-
The electronic monitor is made up of two distinct areas:
The top area, Fig.2 (A – B – C) for the DISPLAY
The bottom area, Fig.3 (E – F – G) for the KEYPAD
DISPLAY.-
This area comprises of two screens.
(A) The top LED array, which displays real-time exertion levels being produced during the selected program.
(B) Bottom alphanumeric screen, which guides the user selection options and exercise.
The top screen (A) displays the various pre-programmed exercise profiles (programs) that we can select and,
during exercise, current exertion levels.
The bottom alphanumeric screen (B) is used to guide the user when selecting the exercise to do, as well as
displaying information about the exercise both during and after the session. The LED indicators (C) located
below the alphanumeric screen give a simultaneous readout of SPEED; TIME / DISTANCE; CALORIES /
WATTS; PULSE RATE and indicate which information is being displayed throughout the exercise.
The data that are displayed on the LEDs (C) during exercise are as follows:
-SPEED: This displays the linear velocity at which the belt is travelling. The value is displayed in kilometres
per hour (km/h).
-TIME: This shows the time that has elapsed since you started the exercise or, if a time limit has been
established, the amount of time left before the exercise finishes. The time is displayed in minutes and
seconds (mm:ss).
-DISTANCE: This shows the distance that you have travelled since beginning the exercise. The distance is
calculated by using the estimated linear velocity (SPEED) and the units displayed are kilometres and
hectometres
-CALORIES: This shows the estimated number of calories that have been burnt off up until now. This
calculation is based on the energy being produced and the weight and age values provided by the user.
PERSONALISED SETTINGS PANEL
(Enabled)
- OFF (Disabled)
- ON (Allows the welcome message to be edited)
- Exercise time limit values in minutes (maximum 60)
and SPEED- keys and then press ENTER to confirm,
key, press ENTER.
Description
12
SK
LINE LINE
LINE LINE
sportkoncept