Setting The Basic Functions; Switching On The Device For The First Time; The Standby Menu - Sonoro sonoroCD Instrucciones De Manejo

3. Slowly turn the click wheel to the right to
increase the volume.

8 Setting the basic functions

The individual menus let you select the functions and
settings of the device.
Switching on the device for the first
8.1
time
After you have switched the device on for the first
time, the LCD display shows the clock display and the
[Tune to FM RDS station to set time & date]message.
i
In FM/DAB mode, time and date are set automati‐
cally as long as this has not been disabled.
8.2

The Standby menu

You can adjust the following settings in the Standby
menu:
n Manually set the time.
n Manually set the date.
n Switch on/off the date on the display.
The procedure for setting the individual functions is
the same.
Setting the time manually
Fig. 10: Setting the time
1. Press the [MENU] button on the device or the
remote control in Standby mode.
ð The display shows the [Set Time] menu
(Fig. 10).
2. Press the click wheel to set the hours.
ð The hour display flashes.
3. Turn the click wheel to set the hours.
4. Press the click wheel to confirm the setting.
ð The minute display flashes.
5. Turn the click wheel to set the minutes.
6. Press the click wheel to confirm the setting.
ð The time is set.
52
i
Use the [Next] or [Previous] button to
switch between the hours and minutes
display.
i
After 10 seconds of inactivity, the device automat‐
ically goes into Standby mode without saving the
settings.
Setting the date manually
Fig. 11: Setting the date
1. Press the [MENU] button in Standby mode on
the device or the remote control.
ð The display shows the [Set Time] menu
(Fig. 10).
2. Press the [Next] button.
ð The display shows the [Set Date] menu
(Fig. 11).
3. Press the click wheel.
ð You can now set the date according to the
same procedure as described in
the time manually' on page 52.
Switching on/off the date
Fig. 12: Switching on/off the date
1. Press the [MENU] button of the device or the
remote control in Standby mode.
ð The display shows the [Set Time] menu
(Fig. 10).
2. Press the [Next] button twice.
ð The display shows the [Date] menu (Fig. 12).
3. Press the click wheel.
ð You can now switch the date on or off.
Ä 'Setting
© 2013