König Electronic SEC-ALARM100 Manual De Uso página 5

Description remote control (SEC-ALARM100/110/120):
Figure 5
Off button
Installation SEC-ALARM100
1. Insert, according the diagram inside the battery compartment, (backside) the batteries for the alarm
unit (3x AA).
2. Install the door/window sensor with the adhesive tape to doors and windows. Note: maximum 1 cm
distance between magnetic contact and sensor (see figure 2). Switch on the sensor to RF or
RF+ALARM. If switched to RF+ALARM, the sensor will send, when triggered, a signal to the alarm
unit and the siren of the sensor itself will also sound. In this case the siren of the sensor and the
alarm unit will both sound.
3. Remove the transparent front cover of the alarm unit to write down the position of the sensors
corresponding with the numbered LED. (e.g. sensor 1 = front door, 2= kitchen window, etc.).
4. Install the alarm unit to a location. The distance between the alarm unit and the most far away
door/window sensor may not exceed 60 m (open area)*
5. Switch on the alarm unit to ALARM or CHIME function. If switched to CHIME, the alarm unit will
sound like a door bell when a door or window is opened. Switched to ALARM generates a 100 dB
loud siren. When the alarm unit is switched on, the alarm is not armed (active) yet. Push the ON
button on the remote control to arm the alarm and OFF to disarm. The delay time for entering and
leaving the protected area is between 20~25 seconds.
6. It's recommended to test the alarm system for correct operation with fi rst use and every 3 months.
Procedure:
a) Switch the alarm unit on to ALARM or CHIME (for testing recommended).
b) Push the ON button on the remote control to arm the alarm.
c) Wait for 20~25 seconds (delay time).
d) Open every door or window one by one and check if the corresponding LED lights up and the
CHIME sounds.
e) Disarm the alarm if everything operates correct.
f) The alarm system is ready to use.
LED indicator
5
On button