DT SWISS D 232 Manual De Instrucciones página 17

3.3 FITTING THE SEAT POST
1. Clean and degrease the seat post and the seat tube of the bike frame.
2. Lightly grease the seat tube for a seat post made of aluminum. Apply carbon assembly paste onto
the seat tube of a seat post made of carbon.
3. Insert the seat post into the bike frame.
→ The seat post must be inserted at
least 90 mm into the bike frame and
up to the "MIN. INSERTION" mark.
→ The seat post may be inserted by
a maximum of 190 mm into the
bike frame and up to the "MAX.
INSERTION" mark.
→ The seat post must be aligned so
that the "FRONT" mark on the
saddle clamp points in the direction
of travel.
4. Tighten the seat post clamp.
→ A screw-type seat post clamp may
be tightened with a maximum of
5 Nm tightening torque.
→ A seat post clamp with a quick
release may only be tightened to
the extent that the seat post cannot
be rotated by applying moderate
manual force.
.
MAX. INSERTION
MIN. INSERTION
MAX. 5 Nm
D 232 - User Manual V2020.02
17