DT SWISS D 232 Manual De Instrucciones página 21

3.8 ATTACHING THE CABLE TO THE SEAT POST AND FITTING THE SEAT POST
A
1. Pull the cable housing a few centimeters out of the seat tube.
→ Make sure that you do not pull the cable housing into the bike frame.
2. Push an ferrule onto the cable housing.
→ The ferrule must not have an outer diameter of more than 6 mm.
→ The ferrule must not have a liner.
3. Push the cable through the cable housing (A) starting at the seat tube.
4. Attach the cable to the quickconnector and attach the cable housing with ferrule to the
quickconnector (B).
5. Pull on the front end of the cable to tension it.
6. Push the seat post into the bike frame to the seat height determined previously. At the same time,
pull lightly on the cable and cable housing.
7. Tighten the seat post clamp.
→ A screw-type seat post clamp may be tightened with a maximum of 5 Nm tightening torque.
→ A seat post clamp with a quick release may only be tightened to the extent that the seat post
cannot be rotated by applying moderate manual force.
D 232 - User Manual V2020.02
B
21