Delivery Specification; Safety Devices - Mafell KSP 55 Manual De Instrucciones Original Y Lista De Piezas De Recambio

Saw blade speed
Cutting speed - nominal load
Hose connector diameter
Weight with battery, without parallel guide fence
Dimensions (W x L x H)
Battery-Powered Motor
Power input (normal load)
Power output
Current - nominal load
1.4 Noise emission
Noise emission values determined according to EN 60745-1 and EN 60745-2-5:
Operation
The noise measurement was recorded using the saw blade included in the standard equipment.
The stated values do not take any series variance into account and are not suitable for determining the immis-
sion sound power level, since this varies depending on the operating time, the machining operation concerned
and environmental factors. The immission sound power level can consequently be determined only in the indi-
vidual instance on the premises of the machine user.
1.5 Vibration
The typical hand-arm vibration is less than 2.5 m/s
1.6

Delivery specification

Cordless portable circular saw KSP 55 / 24 V complete with:
∅
1 TCT saw blade 160 mm, (6 1/4 in.), 16 teeth
1 riving knife / splitter (thickness 1.2 mm / 3/64 in.)
1 hose connector
1 parallel guide fence
1 APS Akku - Power - Station
1 interchangeable battery 24 V, 2.4 Ah
1 service tool in holding device on the machine
1 "MAX" transport case
1 operating manual
1 "APS Akku - Power - Station" operating manual
1 folder "Safety instructions"
1.7

Safety devices

Great attention was paid to the safeguarding of opti-
mum working conditions right from the early devel-
opment stage of this new machine. A wide variety of
mechanical and electrical safety devices, ergonomic
principles and measures to reduce noise and dust
emissions were employed. In accordance with the
European Standards and with regard to the required
protection devices stipulated by the use according to
no load
nominal load
205 x 355 x 262 mm (8 7/8 x 13 9/76 x 10 3/15 in.)
Sound power level
107 dB (A)
.
2
intended purpose, the machine is protected against
dangers which could not be eliminated by its design.
The protection devices are in particular:
Protection against contact with the tool:
In accordance with the requirements of
EN 60745-2-5, the tooth rim of the saw blade
not required for cutting is secured by a fixed saw
guard and the part required for cutting is
-16-
3000 rpm
2400 rpm
19,2m/s (63 ft/sec)
35 mm (1 3/8 in.)
4.7 kg (10.34 lbs)
Emission sound pressure level
96 dB (A)
24 V
340 W
210 W
15.5 A