Operation; Starting The Engine - Makita EB5300TH Manual De Instrucciones

OPERATION

Starting the engine

WARNING:
Never attempt engine start
in a place where the fuel has been supplied.
It may cause ignition or fire. When starting
the engine, keep a distance of at least 3
meters from fuelling place.
WARNING:
Exhaust gas from the
engine is toxic. Do not operate the engine
in a poorly-ventilated place, such as in a
tunnel, building, etc. Operating the engine in
the poorly-ventilated place may cause poison-
ing by exhaust gas.
WARNING:
In case of detection of any
abnormality in sound, odor, vibration after
starting, stop the engine immediately and
carry out inspection. If the engine is operated
without attending such abnormality, an acci-
dent may occur.
WARNING:
Do not touch hot engine
cover. Otherwise skin burn may result.
WARNING:
Make sure that there is no
fuel leakage before starting the engine.
WARNING:
Make sure that the engine
stops when the stop switch is set to "O"
position.
When the engine is cold or after
refuelling (cold start)
1. Put the blower on a flat surface.
2. I / O position
For tube throttle model: Set the stop control
lever to "I" position.
1
► 1. Stop control lever
For hip throttle model: Set the stop switch to "I"
position. And make sure that the throttle lever is
set to low speed position.
► 1. Stop switch 2. Throttle lever
3. Continue to push the primer pump until fuel
comes into the primer pump.
1
2
► 1. Choke lever 2. Primer pump
NOTE: In general, fuel comes into the carbure-
tor by 7 to 10 pushes.
NOTE: Even the primer pump is pushed
excessively, an excess of gasoline returns to
the fuel tank.
4. Lift the choke lever to the closed position.
5. Put your left hand on the top of the blower
and pull the starter handle slowly with your right
hand until you feel the compression. Then pull
the starter handle strongly.
13 ENGLISH
2
1