Makita EB5300TH Manual De Instrucciones página 21

► 1. Throttle valve 2. Idling adjusting screw
3. Control cable 4. Throttle valve stopper
If the throttle valve does not touch the throttle
valve stopper even you pull the throttle trigger
fully or if the throttle valve does not touch the
idling adjusting screw while idling, turn the cable
adjusting bolt as follows:
1.
Loosen the fixing nut.
2.
If the throttle valve does not touch the throt-
tle valve stopper, turn the cable adjusting bolt
counterclockwise.
If the throttle valve does not touch the idling adjust-
ing screw, turn the cable adjusting bolt clockwise.
1
► 1. Cable adjusting bolt 2. Fixing nut
3. Tighten the fixing nut to fasten the cable
adjusting bolt.
4.
Check the movement of the throttle valve. The
throttle valve comes to the position as illustrated
when the throttle trigger/lever is pulled/turned.
1
4 3 2
2
21
Cleaning carburetor cover
If the carburetor cover gets dirty and it is difficult
to check the throttle valve, clean the carburetor
cover as follows:
NOTICE:
Never use gasoline, benzine,
thinner, alcohol or the like for cleaning
the carburetor cover. Otherwise it may be
tarnished.
1. Pass a slotted screwdriver through the hole
on the engine cover. Release the clamp of the
carburetor cover.
1
► 1. Carburetor cover
2. Clean the carburetor cover.
NOTICE:
Use wet clean cloth for cleaning
the carburetor cover.
3.
Return the carburetor cover. Make sure the
clamp of the carburetor cover clicks when it is
set in place.
ENGLISH