Safety Features; Motor Protection (Overload Protection Switch); Cleaning - ROTOR MEMORY BLENDER 2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

© Rotor Lips AG
Automatic switch off (Safety function against unintentional operation)
After 15 min. without a button being pressed, the machine stops and switches automatically to
the standby state.
After 1 hour without a button being pressed, the controller disables the buttons. This status
is indicated by the red LED on the "SAVE" button. To continue operation, the blender must be
reset by switching the mains switch OFF and ON.
Press button combination
Press the buttons 1+2+5+6 in
succession and hold them until
LEDs light up.
Press the buttons 1+2+3+4 in
succession and hold them until
LEDs light up.

9. SAFETY FEATURES

The safety control prevents the motor from being switched on when the Sound enclou-
sure is open, and stops it if the Sound enclousure is raised during operation.
When the Sound enclousure is closed, the cycle must be new started (reset function).
The „SAVE"-Button flashes red, if the sound enclousure is open.
10. MOTOR PROTECTION (OVERLOAD PROTECTION SWITCH )
When the machine is overloaded or overheated, it switches off
automatically.
When the machine stops automatically, immediately remove the complete con-
tainer from the motor unit, pull out the plug and swich off (0) the machine.
After about 60 seconds press the main switch 1/0 on the side
of motor base as usual.
Charge the machine less than before.

11. CLEANING

Pull out the plug before cleaning!
The motor unit must never be submerged in, or sprayed with water
or any other liquid! Never attempt to clean it with a water jet!
22
Instruction Manual
Rotor Memory Blender 2
Function ("AUTOMATIC" mode)
Overwrite protection of user programmes
- Save function is blocked. Programming no longer
possible.
- Blocking is lifted again with the same combination
Reset to manufacturer's settings
- All user programmed cycles are deleted.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

RmbRmb ic

Tabla de contenido