Mattresses; Safety Information On Electromagnetic Interference; Labels And Symbols On The Product; Identification Label - Invacare Medley Ergo Manual Del Usuario

CAUTION!
Risk of injury or damage
The product can get hot when exposed to sunlight
or other heat sources.
– Do not expose the product to direct sunlight for
prolonged periods.
– Keep the product away from heat sources.
CAUTION!
There is a risk of entrapment of fingers in the
bed moving parts.
– Pay attention to your fingers.
IMPORTANT!
The bed has no isolator (main switch). If the bed
needs to be electrically disconnected, it has to be
unplugged from the mains socket.
– Always place the bed in a way so the mains
socket is easily accessible to unplug the bed.
IMPORTANT!
Accumulation of lint, dust and other dirt can
impair the product.
– Keep the product clean.

2.2 Mattresses

WARNING!
Safety aspects regarding combination of side
rails and mattresses:
To get the highest possible safety level, when
using side rails on the bed, the minimum and
maximum measures for mattresses, must be
respected.
– For correct mattress measures see mattress
table in chapter 9 Technical Data, page 24.
WARNING!
Risk of entrapment and/or suffocation
– The user could get trapped and/or suffocate, if
the horizontal space, between the mattress side
and the inside of the side rail, is too big. Follow
the minimum width (and length) of mattresses
in combination with a side rail, as stated in
the mattress table in chapter 9 Technical Data,
page 24 .
– Be aware that using very thick or soft
mattresses (low density), or a combination of
these, increases the risk.
WARNING!
Risk of falling
The user can fall over the edge and get seriously
injured, if the vertical distance A between the
top of the mattress and the edge of the side
rail/bed end, is too short. See image above.
– Always keep a minimum distance A of 22 cm.
1556305-H
A
– Follow the maximum mattress height in
combination with the side rail as stated in the
mattress table in chapter 9 Technical Data,
page 24.
2.3 Safety information on
electromagnetic interference
WARNING!
Risk of malfunction due to electromagnetic
interference
Electromagnetic interference between this
product and other electrical equipment can occur
and disturb the electrical adjustment functions
of this product. To prevent, reduce or eliminate
such electromagnetic interference:
– Only use original cables, accessories and spare
parts, to not increase electromagnetic emission
or reduce electromagnetic immunity of this
product.
– Do not use portable radio frequency (RF)
communications equipment closer than 30 cm
to any part of this product (including cables).
– Do not use this product near active
high-frequency surgical equipment and the
RF shielded room of a system for magnetic
resonance imaging, where the intensity of
electromagnetic disturbances is high.
– If disturbances occur, increase the distance
between this product and the other equipment
or switch it off.
– Refer to the detailed information and follow
the guidance in chapter 10 Electromagnetic
compatibility (EMC), page 26.
WARNING!
Risk of malfunction due to electromagnetic
interference
Do not use this bed adjacent to or stacked with
other electrical equipment, than specified in the
following, as it could result in improper operation.
If such use is necessary, the bed and the other
equipment must be closely observed to verify
that they are operating normally.
This bed can be used together with Invacare
approved accessories and medical electrical
equipment connected to the heart (intracardially)
or blood vessels (intravascularly) provided that
following points are respected:
– Medical electrical equipment should not be
fixed on the bed's metallic accessories such as
side rails, lifting pole, drip rod, bed ends, etc.
– The medical electrical equipment power supply
cord should be kept clear of the accessories or
any other moving parts of the bed.

2.4 Labels and symbols on the product

2.4.1 Identification label

The identification label is placed on the frame of the bed and
contains the main product information, including technical
data.
Safety
7