DeWalt DWE4012 Manual De Instrucciones página 10

ATTACHING SIDE HANDLE (FIG. 2) FIG.2 c
The side handle (C) can be fitted to either side of
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened securely. Use a wrench to firmly
tighten the side handle.
Ftotating the Gear Case
(Fig. 3)
1. Remove the four corner screws FIG.3
attaching the gear case to motor
housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position. 90°
NOTE: If the gear case and motor housing
become separated by more than 1/8"
(3.17 mm), the tool must be serviced and re-assembled by a DEWALT
service center. Failure to have the tool serviced may cause brush,
motor and bearing failure.
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 18 in.-Ibs, torque. Overtightening could cause
screws to strip.
A WARNING: Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off.
Accessories and Attachments
The capacity of this tool is 4-1/2" (114.3 ram) diameter x 1/4"
(6.35 mm) thick grinding or cutting wheels. It is important to choose
the correct guards, backing pads and flanges to use with grinder
accessories. See pages 9-10 for information on choosing the correct
accessories.
4= 1/2" (114.3 mmJ Grinding Wheels
Type 27 guard
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Type 27 guard
Type 27 hubbed wheel
Wire Wheels
Type 27 guard
3" (76.2 ram)
wire cup brush
Type 27 guard
4" (101.6 mm) wire wheel