Air Supply - Hitachi N 3804AB2 Instrucciones Y Manual De Seguridad

English

AIR SUPPLY

Never connect Stapler to pressure which potentially exceeds 200
psi (13.7 bar 14 kgf/cm
Never use non relieving coupler on Stapler.
1. Power source
Use only clean, dry, regulated compressed air as a power source for this Stapler.
Air compressors used to supply compressed air to this Stapler must comply with the
requirements of the latest version of ANSI Standard B 19.3 "Safety Standard For
Compressors For Process Industries."
Moisture or oil in the air compressor may accelerate wear and corrosion in the Stapler.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of 0 – 120 psi (0 – 8.3 bar 0 – 8.5 kgf/cm
Filter-regulator-lubricator units supply an optimum condition for the Stapler and extend
the Stapler life. These units should always be used.
Filter ............. The filter removes moisture
and dirt mixed in compressed
air.
Drain daily unless fitted with
an automatic drain.
Keep the filter clean by
regular maintenance.
Regulator ..... The regulator controls the
operating pressure for safe
operation of the Stapler.
Inspect the regulator before
operation to be sure it
operates properly.
Lubricator .... The lubricator supplies an oil mist to the Stapler.
Inspect the lubricator before operation to be sure the supply of lubricant
is adequate.
Use Hitachi pneumatic tool lubricant.
12
DANGER
NEVER use oxygen or other bottled
gases. Explosion may occur.
WARNING
2
).
Stapler
Side
Regulator
Compressor
Side
Filter
Lubricator
2
).