Rs232 Output; Cleaning; Replacement Fuse - TENTECH MPK-254 Manual De Uso

7. RS232 output

The equipment has an RS232
be used to register measurements in a serial printer or data collector. The
outputs are the following ones:
Pin 2: Rx ; Pin 3: Tx ; Pin 5: Gnd;
Rate: 4800 bps
8 bits - no parity - 1 stop bit (8,n,1)
Note: In order to assure the compatibility with most printers available in
the market, the resistance units are shown with the following symbols:
uR = micro-ohm
mR = milli-ohm
R = ohm

8. Cleaning

The panel, terminals and connectors of the equipment must stay dry and
clean. Cleaning should be made using a wet cloth in water and a soft
detergent or isopropyl alcohol (be sure that the products to be used for
cleaning does not affect plastic).
9.

Replacement fuse

To check the instrument fuse
is ruptured replace it by another with the following specifications:
Fuse Schurter, model SPT 5x20 (Time-lag) 5A/250V. High breaking capacity.
data output in the control panel that can
, remove it with a screw driver. If the fuse
13