Measurement - TENTECH MPK-254 Manual De Uso

4. Measurement

It should be checked that the item to be measured is voltage free.
1. Before turning the equipment On, connect the test leads to the item to
be measured and to the front panel terminals.
R
The alligator clamps in the drawing are only for illustration.
2. Using the test current selector
to be used.
3. Switch the equipment On using the On/Off
4. The PRESS START message will appear showing that measurement
can be started. Press the Start
the test current control
up.
5. Turning the test current control
Adjust this control until obtaining the desired value or until the current
indicator (bargraph) indicates 100%. The bargraph will show the test
current value as a percentage of the nominal value selected by using
the test current selector
, choose the range and the current
.
key. Depending on the position of
the LOW CURRENT message will turn
clockwise increases the current.
.
9
5 4 3 2
1
9 8 7 6