Weka KS50 Instrucciones De Funcionamiento página 13

6.1 Adjusting the guide slide bearings
For achieving good drilling results, the clearance between feed case (3) and rig column (2) has to be as
low as possible. If the clearance is too big (>0,1mm) the guidance can be adjusted by proceeding as
follows:
Loosen the four raised head screws and the ten hexagon nuts (33) at the feed case. Turn the ten thread
pins (32) with a slotted screwdriver clockwise until the guide slide bearings rest to the rig column free of
clearance. If the guiding behaviour is sufficient free of clearance however still free moving, tighten the
four raised head screws and the ten hexagon nuts again.
6.2 Exchanging the guide angles (part no.: KS50708)
If the sliding surface of the guide angles is worn out, these have to be exchanged. Thereby proceed as
follows:
Remove the column head, resp. head plate (4, 15). Tear the complete feed case off.
Remove the four raised head screws (34). Loosen the ten hexagon nuts (33) and turn the thread pins (32)
back. Exchange the four guide angles and screw these in reversed order.
Push the complete feed case to the column again and adjust the clearance as described under 4.1.
6.3 Exchanging the holding plate (part no.: KS50728)
Remove the retaining ring and the wasger. Remove the clamp shaft and exchange the holding plate.
When assembling the clamping shaft again, ensure that the contact area are slightly greased. Apply the
washer and the retaining ring again.
7. G U A R A N T E E
This product is covered by a guarantee for a period of 12 months from the date of purchase.
The guarantee covers all defects or damages of the product during the guarantee period evidently due
the defaults in workmanship or material and is limited to repair and/or adjustment. The guarantee is not
valid in case of normally wear and tear, if the product has been misused, used contrary to the instruction
manual, or by using extraneous parts.
8. D E C L A R A T I O N O F C O N F O R M I T Y
Description:
Type:
from serial no.:
We hereby declare under our sole responsibility that this product conforms to the regulations of directive
2006/42/EG and 2011/65/EU.
WEKA Elektrowerkzeuge
Auf der Höhe 20
D 75387 Neubulach
9. R E C Y C L I N G
According to the European regulation 2002/96/EG we have to take back old machines for
departing them by substance and for recycling (see sign on name plate). Please make sure
that the old tool does not get into the unsorted municipal solid waste, but that it is given back
to us, resp. abroad to our distributors.
Drill rig - for fixing core drilling machines
KS50 (and versions)
0110001
Übersetzung der Originalbetriebsanleitung - Subject to change without notice 0610
Neubulach, 29.12.2009
Wilhelm Wurster, Owner
10