sary to service your bar. A worn bar will dam-
age your chain and make cutting
difficult.
Replace your bar if bent or the inside rails of
the bar are worn.
• Clean the oil holes after each 5 hours of
operation.
• Remove sawdust
from bar groove periodi-
cally with a wire or putty knife.
Sprocket
Hole
•
oc
CHAIN
SHARPENING
Chain sharpening
is a complicated
task that
requires
special
tools.
We recommended
you refer chain sharpening
to a professional
chain sharpener.
IGNITION
TIMING
Ignition timing is fixed and nonadjustable.
SPARK
PLUG
Replace the spark p_ug yearly using a Cham-
pion RCJ6Y.
Gap to .025".
TROUBLESHOOTING
TABLE
STORAGE
'_
WARNING:
stop engine and allow to
cool, and secure
the unit before storing
or
transporting
in a vehicle.
Store unit and fuel
in an area where
fuel vapors
cannot
reach
sparks
or open flames
from water heaters,
electric
motors
or switches,
furnaces,
etc.
Store unit with all guards in place. Position so
that any sharp
object
cannot
accidentally
cause injury to passersby.
Store the unit out
of reach of children.
• Before storing,
drain aH fuel from the unit.
Start engine and allow to run until it stops.
• Clean the unit before storing.
Pay particu-
lar attention
to the air intake area, keeping
it free of debris. Use a mild detergent
and
sponge to ctean the plastic surfaces.
• Do not store the unit or fuel in a closed area
where fuet vapors can reach sparks
or an
open flame from hot water heaters, electric
motors or switches,
furnaces,
etc.
• Store in a dry area out of reach of children.
CAUTION:
It is important to prevent
gum
deposits
from forming
in essential
fuel sys-
tem parts such as the carburetor,
fuel filter,
fuel hose. or fuel tank during
storage.
Alco-
hol blended
fuels
(called gasohol
or using
ethanol
or methanol)
can attract
moisture
which
leads to fuel mixture
separation
and
formation
of acids during storage.
Acidic gas
can damage
the engine.
_, WARNING:
Always
stop unit and disconnect
spark plug before performing
all of
the recommended
remedies
below except
remedies
that require operation
of the unit.
TROUBLE
REMEDY
Engine will not
start or will run
only a few
seconds
after
starting.
CAUSE
• Ignition switch off.
• Engine flooded,
• Fuel tank empty.
• Spark
plug not firing.
• Fuel not reaching
. carburetor.
•
Move ignition switch to ON.
•
See"Difficult
Starting"
in
Operation
Section.
•
Fill tank with correct fuel mixture.
•
Install new spark plug.
•
Check for dirty fuel filter; replace.
Check for kinked or split fuet line;
repair or replace.
•
Contact
an Authorized
Service Dealer.
Engine will
• Carburetor
requires
not idle
. adjustment
properly.
• Crankshaft
seals worn.
•
Contact
an Authorized
Service Dealer.
Engine will not
• Air filter dirty.
•
Clean or replace air filter.
accelerate,
• Spark
plug fouled.
•
Clean or replace
plug
lacks power,
and regap.
or dies under
• Carburetor
requires
•
Contact
an Authorized
Service
Dealer.
a load.
adjustment.
Engine
• Too much oil mixed with
• Empty fue_ tank and refill with
smokes
. gasoline.
. correct fuel mixture.
excessively.
13