Prior To Operation - Hitachi G 14DSL Manual De Instrucciones

CAUTION
●
When the battery charger has been continuosly
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes rest
until the next charging.
●
If the battery is rechraged when it is warm due to
battery use or exposure to sunlight, the pilot lamp
may light in green.
The battery will not be recharged. In such a case,
let the battery cool before charging.
●
When the pilot lamp flikers rapidly in red (at 0.2–
second intervals), check for and take out any
foreign objects in the charger's battery installation
hole. If there are no foreign objects, it is probable
that the battery or charger is malfunctioning. Take
it to your authorized Service Center.

PRIOR TO OPERATION

1. Power switch
Ensure that the switch is in the OFF position.
2. Check your work environment
Ensure the following before operation:
No flammable gas, liquid, or object at
worksite.
When grinding thin steel sheet it may cause
a high booming noise.
To avoid such noise, place a rubber mat under
the workpiece.
Clear the area of children or unauthorized
personnel.
3. Mounting the wheel guard
Be sure to mount the wheel guard at an angle that
will protect the operator's body from injury by a
broken wheel piece.
[Installing Wheel Guard]
Slightly loosen the screw on the wheel guard.
Install the wheel guard to the packing gland,
turn it to the angle suitable for operation, and
make adjustment.
After the adjustment, ensure that the screw
is securely tightened on the wheel guard in
order to fix it completely.
Wheel guard
Packing gland
WARNING
If the wheel guard is not attached properly, a
broken wheel may result in and cause death or
serious injury.
4. Thoroughly check that the depressed center wheel
is free of cracks, splits and other abnomalities
before mounting. Make sure it is firmly clamped
and has been properly mounted. Refer to page 17
of this manual for Depressed Center Wheel
Assembly and Disassembly
5. Test the grinder before using.
Before actually beginning the grinding work, test
the grinder by first clearing the area of all other
personnel. Make sure the wheel guard is in place
and that you are wearing eye protection. Turn the
grinder "on", and make sure the grinder runs
smoothly and shows no abnormalities.
Duration of the trial run is as follows:
When depressed center wheel
is replaced ............................... 3 minutes or
more
When starting daily work ...... 1 minute or
more
6. Use only properly rated depressed center wheels.
Use only depressed center wheels rated at 13,300
RPM or more.
Using a depressed center wheel rated less can lead
to wheel disintegration during operation and cause
serious bodily injury.
7. Check the push button.
Make sure that the push button is disengaged by
pushing push button two or three times before
turning on the grinder. (Fig. 8)
8. About Remaining Battery Indicator
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
English
Fig. 5
15