Pad Change; Wheel Adjustment; Dust Bag - Nilfisk-Advance PBU Serie Libro De Instrucciones

Pad Change

1. Close the valve on the propane cylinder, allow the
engine to stop and turn the machine OFF.
2. Remove the propane cylinder.
3. Raise the handle to the full-up position (about a 45°
angle).
4. Lift up on the front of the deck, rocking the machine
back until it rests on the handle grips.
5. Remove centering device and inspect pad. If pad
has worn to less than a 1/4" (6mm) thick, replace it.
CAUTION! Carefully inspect the pad holder for cracks
or damage. Replace if necessary.
WARNING! A damaged pad holder rotating at high
speeds may be an extreme hazard if it should come
apart.
6. When lowering the machine down, DO NOT drop the
machine. Slowly lower the machine to the floor until
the wheels are on the ground.

Wheel Adjustment

1. Close the valve on the propane cylinder, allow the
engine to stop and turn the machine OFF.
2. Remove the propane cylinder.
3. Raise the handle to the full-up position (about a 45°
angle).
4. Rock the machine by lifting up on the front of the
machine until it rests on the handle grips.
5. Remove the clevis pin that retains each wheel and
relocate to the desired wheel position.
NOTE: To increase pad pressure (more aggressive)
move wheels to rear of machine. To decrease pad
pressure (less aggressive) move wheels toward the
front of machine.

Dust Bag

1. Pull dust bag downward off dust tube by holding at
the front and pulling down and to the rear to remove.
2. Empty bag by rubbing or gently tapping on sides, in a
downward motion, to loosen soil trapped on sides of
bag. For heavy soil, turn bag inside out to clean.
3. Reinstall bag by hooking elastic edge onto back of
dust tube lip, and fitting elastic around dust tube.
A15