Publicidad
Idiomas disponibles
Idiomas disponibles
and water
Filter Change and Reset (RX256DT4X1 / RX216DT4X1}
The water filter needs to be replaced every 12 months, or after 750 gallons (2838 liters) have
been dispensed
(which ever is sooner).
When it is time to replace the filter, the filter change light will turn red. It will remain red until
reset.
To reset filter indicator,
press both dispenser
LOCK/UNLOCK and WATER buttons at the same
time, and hold for four seconds.
Make sure green light flashes three times when indicator
resets.
For filter reset on RX256DT7Xl
see page 14.
Automatic ice maker
Connect the ice maker to the water supply as instructed
on pages 9 - 10. Proper water flow
and a level refrigerator
are essential for optimal
ice maker performance.
Note: energy rating guides that are posted on the refrigerator
at the time of purchase do not
include optional
ice maker energy usage.
Operating
instructions
To start ice making
Confirm
ice storage bin is securely in place,
Lower the wire arm inside the ice bin gently,
Once the freezer corn partment
has reached O'_'F (--18_'C), t he
ice maker will fill with water.
Approximately
three to six hours after instalhtion
the first
batch of ice will be produced.
After the initial ice batch is made, a complete
batch will be
made every two to three hours.
Discard ice made in the first 12 hours of operation.
The ice maker will continue
to make ice until the ice level
raises the wire arm, and stops production.
To stop ice production
Lift the wire arm inside the ice bin until a click is heard.
The ice maker will not make or dispense ice until the arm is
lowered.
To remove
the ice bin
Stop ice production
by raising the wire arm.
Lift the ice bin up slightly and pull forward.
To install the ice bin
Turn the auger driver behind the ice bin a half turn
co u nte rcIoc kwise.
Place the bin in the rails and slide back gently.
Fig.17Auger driver
Publicidad
