Publicidad
Idiomas disponibles
Idiomas disponibles
Ice and water
Water flow is
slower than
normal
Dispenser
water is
not cold°
Water appears
dourly°
Particles in water
and/or
ice cubes,
Water pressure is too low.
Water pressure must be between
35 to 1O0
pounds per square inch to function
properly.
A minimum
pressure of 35 pounds per square
inch is recommended
for refrigerators
with
Saddle valve not open
Open saddle valve completely.
completely.
Improper
saddle valve was
See connecting
the water supply,
installed,
pages 9 - 10. Self--piercing and 346"(4.7 ram)
saddle valves cause low water pressure and
may dog the line over time, The manufacturer
is not responsible
for property damage due to
Copper tubing
has kinks.
Turn off water supply and remove kinks,
If kinks cannot be removed, replace tubing_
Water filter is dogged
or
Change water filter (see page 25).
needs to be changed,
Water valve not opened
completely.
Refrigerator
has been
recently
installed.
Water supply in homing
tank has been depleted.
Air or air bubbles in water.
Carbon dust from water
filter cartridge.
Concentrations
of minerals
in water will form particles
when water becomes
frozen and melts.
:: Open water valve completely
and check
for leaks. The minimum
flow at dispenser is
approximately
10 fluid ounces in nine seconds
with a new filter in place or approximately
10
fluid ounces in five seconds without
a filter.
Allow approximately 12 hours for water in
holding tankto chill.
This is normal when first using the dispenser
and will disappear
with use.
Initial water ejected through
cartridge
may
contain
harmless carbon dust flushed
from
cartridge. Will disappear after the first few
uses,
Particles are not harmful and naturally
occur in
water supplies_
i
i
Publicidad
