Southland SFTT142 Manual De Operación página 15

Operation
(Continued)
• Save all instructions
H
Clutch Lever
NOTICE
When tilling, always pull lever completely to the handle.
Failure to do so may result in excessive drive belt wear and
premature drive belt failure.
CAUTION
This information is provided here only to introduce the
controls. Do not start the engine at this time. Starting and
operating instructions are given on page 11. Please read
this section and all operating and safety instructions before
starting your tiller.
WARNING
Do not fix the clutch lever in drive position by any other
means than manually using your hand. DO NOT tie or oth-
erwise secure the lever in drive position.
• To stop the tines at any time release the clutch lever.
I
Adjustments
Engine should be off before adjusting any controls.
DRAG BAR
(See Figure 2)
Tilling depth is controlled by the height of the drag bar. To
adjust tilling depth:
1. Remove pin.
2. Adjust the drag bar to position tines at chosen tilling depth.
3. Align hole in drag bar with hole in swing plate bracket and
replace pin.
Drag Bar Up = Shallower tilling.
Place the pin in the bottom hole of the drag bar for
shallowest tilling.
Drag Bar Down = Deeper tilling.
Place the pin in the top hole of the drag bar for deepest tilling.
Questions? Call Toll Free at 1-800-737-2112
CLUTCH LEVER
(See Figure 17)
Engage tines by pulling the clutch lever to the handle.
Releasing the lever stops the tines and brings the tiller to a
complete stop.
NOTE: The drag bar must be in the middle or bottom hole for
transporting.
WARNING
Do not adjust tilling depth unless clutch lever is released and engine
is turned off.
ENG - 15
Copyright © 2016 MAT Engine Technologies, LLC
Lever Engaged
Figure 17