Assembly - Southland SFTT142 Manual De Operación

Assembly

• Save all instructions
Read and follow the assembly instructions. Do not discard any parts or materials until the unit is assembled.
References to the right or left side of the tiller are from the viewpoint of the operator's position behind the tiller.
WARNING
Do not operate tiller if it is damaged or not completely and correctly assembled.
WARNING
Before doing any assembly or maintenance to the unit, remove the wire from the spark plug.
WARNING
Always wear ANSI compliant safety glasses with side shields while assembling the tiller.
The following components will be found in the carton.
Quantities shown in ( ).
1. (1) Tiller
2. (1) Upper Handle Assembly
3. (1) Lower Handle
4. (4) Tines
5. (1) Wheel Assembly
6. (1) Drag bar
7. (2) Outside Tine Shields
8. (1) Tiller Operator's Manual
9. (1) Engine Manual
10. (1) Bottle of Engine Oil
11. (1) Parts bag containing the following
a. (4) M10 x 25 mm bolts, flat washers and lock washers for assembling lower handle.
b. (4) M8 x 25 mm saddle bolts and flat washers for assembling upper handle to lower handle.
c. (4) Handle knobs, for upper handle to lower handle.
d. (2) M8 x 50 mm bolts, (4) flat washers and (2) lock nuts for assembling outer tines.
e. (2) M10 x 50 mm bolts, (4) flat washers and (2) M10 locknuts for assembling inner tines.
f. (1) Pin, flat washer and hairpin cotter for drag bar.
g. (6) M6 x 16 bolts, lock nuts, and flat washers for installing outside tine shields.
h. (1) Rope guide with nylock nut.
i. (1) Cable Ties.
A
How to Remove Tiller from Carton
1. Remove all parts and packaging components.
2. Use a utility knife to cut all 4 vertical edges and lay the side panels flat around the tiller.
3. Remove any remaining packaging.
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
ENG - 8
Copyright © 2016 MAT Engine Technologies, LLC