Publicidad
Idiomas disponibles
Idiomas disponibles
AUTOMATIC FEEDING OF SINGLE SHEETS
Follow the below steps for clean automatic paper feeding:
1. Square stack of up to 50 sheets of paper by tapping it on all sides on a flat surface such as a table.
2. Load squared stack of paper into the P7200 feed table, the top sheet of paper should be in contact with the
black feed tire. NOTE: In loading the paper, the stack need only be "pushed" into the feed mecha-
nism with a light touch. Jamming the stack of paper into the folder with force will result in feeding
problems. See figures 12 and 13.
3. Turn the folder 'ON' by pushing the 'I' portion of the 'I-O-II' rocker switch. Folding should initiate. *Note:
Use Martin Yale Static Eliminator (model 300) to remove static and improve machine performance. Also use
Martin Yale Rubber Roller Cleaner (model 200) for better folding perform-
Figure 12
Place stack of
paper here
ance and longer roller life.
Note: Paper is
placed in folder
square. Paper
is not fanned
HAND FEEDING OF SETS (Mandatory when folding multiple sheet sets of paper)
1. To prevent jams, remove all paper from the Paper Tray before feeding sets by hand.
2. For feeding sets of up to 3 sheets (stapled or unstapled), first square the paper against a tabletop.
3. Place the paper into the manual feed slot on the top of the machine (as shown in Figures 13 and 14). Do
not install multiple sheet sets in the Feed Table; a jam will result.
4. Use the momentary on, "II" switch position to initiate folding. Hold switch
down until folded paper exits machine.
5. Do not run machine for long periods of time without paper in the Paper Tray, this
could wear down the feed tire. HINT: For multiple sheet sets of paper, creas-
ing of the stock may be encountered due to the thickness of the multiple
sheet set. Correct by moving the 1st fold table stop out approximately 1/8".
For example, if the 1st fold table were set at 7 3/8" for a letter fold, the user
would reset it to 7 1/2" for the multiple sheet set.
PAPER JAMS
1. Unplug the machine. Check to see if you can clear the jam by removing one of the Fold Tables.
2. If you cannot remove the jam, use a flathead screwdriver to manually turn the folding rollers, using the
access hole in the left side of the machine. The paper should eventually emerge from the machine.
3. You may need to remove the top plastic cover to extract the jammed paper.
TROUBLESHOOTING
PROBLEM:
The paper jams in the machine.
SOLUTION: 1. If feeding by hand, make sure that there is no paper in the Paper Tray.
2. Re-align the Paper Guides and check Fold Table settings.
3. Check to see if paper is within specifications (8
4. Remove top cover and clean rollers with Martin Yale Rubber Roller Cleaner (model 200).
5. Use Martin Yale Static Eliminator (model 300) to remove static in paper.
PROBLEM:
Paper will not feed correctly.
SOLUTION: 1. Paper guides too tight or not parallel to each other, Adjust paper guides as described in
Aligning the Paper Guides section of this instruction manual.
2. If feeding by hand, make sure the paper is properly aligned before placing it in the slot.
3. If feeding by hand, place the set in the slot before turning the machine on.
4. Re-align the Paper Guides.
5. Check to see if paper is within specifications (8
6. The feed tire could be worn. Replace.
Figure 13
Manual feed
Side view of paper loaded
slot used for
multiple sheet
sets of paper.
Folder feeds the
top sheet. Only
the top sheet of
paper should be
in contact with
feed wheel
Figure 14
" x 11" or A4, 16-28 lb. bond or 60-105 gsm).
1/2
" x 11" or A4, 16-28 lb. bond or 60-105 gsm).
1/2
(4)
RapidFOLD
CARACTERISTIQUES TECHNIQUES
• Pliage de papiers au format 8 ½" x 11" ou A4
• Quatre pliages différents
• Pliage de 4000 feuilles/heure
• Se prêtant pour le pliage du papier
(60-105 g/m2)
• Pliage automatique d'une feuille à la fois ou de
jusqu'à 3 feuilles à la fois en mode manuel
C
F
AVERTISSEMENT!
Vérifier que la plieuse est montée et
prête au service avant de la brancher au réseau. Pendant le
fonctionnement, ne pas approcher les mains, les cheveux,
des vêtements légèrement attachés ou des bijoux des
pièces mobiles. Danger de blessures graves! Débrancher la
plieuse du réseau avant tous travaux de service ou de
désassemblage.
INSTRUCTIONS DE SERVICE
Modèle P7200 (110V)
Modèle P720022 (220V)
B
Votre appareil est délivré équipé des
éléments suivants :
A. PLIEUSE RAPIDFOLD
B. GUIDES DE PAPIER (2)
C. TABLE DE PLIAGE AVANT
D. TABLE DE PLIAGE ARRIERE
E. SUPPORTS METALLIQUES (2)
F. JEU DE RACCORDEMENT POUR
D
CORBEILLE DE SORTIE (3)
(le jeu de raccordement pour la
corbeille comprend
3 éléments supérieurs en matière
A
plastique,
3 éléments inférieurs en matière
plastique et
6 vis de montage)
E
251 Wedcor Ave.
Wabash, IN 46992
Customer service: (800)225-5644
Bergheimer Strasse 6-12, D-88677 Markdorf, Germany
www.martinyale.de
www.martinyale.com
Publicidad
