Devise Assembly; Preparing The Device - Easy Home STEAM MOP DM 2012 Manual Del Usuario

Steam Mop

DEVISE ASSEMBLY

• First, take the cleaning head (8) and insert it with the round connecting
piece into the respectively provided opening (opposite side from the handle
(4)) of the basic unit (6). Make sure that the bore hole at the rear of the
basic unit (6) is aligned with the bore hole of the connecting piece of the
cleaning head (8). Now, screw the two parts together using the supplied
short screw.
• Now insert the handle (1) with its respective rod into the respectively
provided opening (at the handle (4)) of the basic unit (6). Ensure that the
steam button (2) points towards the rear of the device and that the bore
hole at the lower end of the rod is aligned with the bore hole of the basic
unit (4). Now, screw the handle (1) to the basic unit (6) using the supplied
long screw.
• Now fasten a fabric cover (11) on the cleaning head (8). You will be able to
recognize how to place the fabric cover (11) on the cleaning head (8) based
on its form. Fasten the fabric cover (11) with the cord and the respective
plastic clip by compressing the clip, pulling at the cord and releasing the
plastic clip again.
The device assembly is now complete.
19
hup-service@h-u-p.com
MODEL: DM 2012 PRODUCT CODE: 40041
USA
Devise assembly
AFTER SALES SUPPORT
USA 1-800-886-8506
10/2015
Steam Mop

PREPARING THE DEVICE

The device must be switched off and disconnected from
the power supply before removing or attaching the water
tank. This also applies when the water tank is being filled
WARNING
while attached to the device.
Do not use the device without properly attached water
tank filled with clean and clear water and without properly
installed fabric cover.
NOTICE
• To remove the water tank (5) from the basic unit (6), slide it up until you
can remove it from the front of the basic unit (6).
• Now fill the water tank (5) with clear water. Ensure that you do not fill the
water tank (5) beyond the "MAX" mark. You can remove the water tank
(5) from the basic unit (6) or fill it by using the supplied measuring cup (9)
with the water tank (5) still attached to the device.
• Place the filled water tank (5) back in the respectively intended bracket at
the basic unit (6).
AFTER SALES SUPPORT
USA 1-800-886-8506
MODEL: DM 2012
USA
Preparing the device
20
hup-service@h-u-p.com
PRODUCT CODE: 40041 10/2015