SOLAC CE4552 Instrucciones De Uso página 9

ENGLISH
The Hot water began to come out of the va-
•
porizer.
Once obtained the desired amount of hot wa-
•
ter, press the coffee icon (E1 or E2) again,
which stops the pump.
Close The turning knob (O) to the right, clock-
•
wise.
OBTAINING STEAM:
The steam is used to foam milk for cappuccino,
•
and also to heat other liquids.
Turn the appliance on using the on/off Icon (F).
•
Place a recipient under the steam tube.
•
Place the tube inside the liquid to be heated.
•
Select Steam option, pushing over Steam Icon
•
(E3).
System will reheat (flashing light) until steam
•
temperature is reached (flashing light will stop).
Open Steam knob (O) turning anticlockwise
•
and steam will start to flow out of the tube.
To better froth the milk, move the jar with slight
•
movements of the jar from top to bottom.
When you have enough, turn back the control
•
knob (O) clockwise until to close it and remove
the recipient.
Use a damp cloth to clean the remains in the
•
steam pipe.
IMPORTANT:
When finished obtaining steam, you must re-
•
place the water used to make steam and at the
same time, recover the temperature (lower) to
make coffee.
To do this, after doing steam, with the steam
•
knob open, press any of the coffee icons, ac-
cording to instructions "Obtaining hot water",
so you will be activating the pump. When water
starts to flow through the steam pipe, it means
that the coffee temperature has returned and
the boiler has been filled. You can now close
the steam control.
AUTO - OFF FEATURE:
The SOLAC machines are designed to save
•
energy.
To that end, after some minutes (9), if during
•
this period the user has not performed any ac-
tion on it, the unit switches to energy saving
mode.
To return to normal operation you should just
•
press the ON/OFF icon (F).
ONCE YOU HAVE FINISHED USING THE AP-
PLIANCE:
Turn the appliance off, pushing over the ON/
•
OFF Icon (F)
Unplug the appliance to the mains.
•
Remove the water from the water tank.
•
Clean the appliance.
•
CLEANING
A. BASIC CLEANING
Disconnect the appliance from the mains and
•
let it cool before undertaking any cleaning task.
Clean the equipment with a damp cloth with a
•
few drops of washingup liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
Do not let water or any other liquid get into the
•
air vents to avoid damage to the inner parts of
the appliance.
Neither parts of this appliance are suitable for
•
cleaning in the dishwasher.
After washing, dry all the parts before fitting
•
them together and storing.
B. CLEANING THE FROTHING WAND
CAUTION! The frothing wand, and frothing
•
sleeve may be VERY HOT.
It is recommended to purge and wipe the froth-
•
ing wand after steaming milk to prevent depos-
its of dirt and before turning off the machine.
To do this, pull the frothing sleeve turning first
•
clockwise and later pulling down, and clean un-
der warm running water.
Fill a cup with a bit of water, immerse the froth-
•
ing wand into the water, open the Water/Steam
Knob.
Press one of coffee Icons (E1 or E2), and Wa-
•
ter will come out. Push again over coffee icon
and water will stop.
Then turn the Water/Steam Knob(O) clock-
•
wise, until to close it.
Use a cloth to dry the frothing wand and re-
•
place the frothing sleeve.
In case no water (or steam) comes out of the
•
frothing wand, hardened milk blocks its path.
Carefully use a needle to loosen the milk resi-
•
due from the opening of the frothing tip
to remove any blockage.
•
Once clean, rinse with running water from the
•
tap and reassemble it. Then steam again.
EN