Amprobe AT-6010-EUR Manual De Usuario página 16

3. MAIN APPLICATIONS - TRACING ENERGIZED AND DE-ENERGIZED WIRES
Setting up the AT-6010-TE Transmitter
1. Press ON/OFF key to turn on the Transmitter.
2. Verify that the test leads are properly connected;
the red LED voltage status light should be on for
circuits with voltage above 30 V AC/DC, and it should
be off for De-energized circuits below 30 V AC/DC.
Note: Make sure to use the separate neutral/ground
connection as described above.
3. HIGH signal mode is automatically activated when
Transmitter is turned on. Screen will appear as shown
in Figure 3.1d.
Using the AT-6010-RE Receiver in Tracing Mode
Use Receiver to precisely pinpoint the wire location or the place of the fault. The Receiver will
indicate detected signal strength using a two digit readout, bar graph and sound.
1. Turn the Receiver on. Tracing mode is automatically activated.
2. Scan target area with the Tip Sensor to find the highest signal level. While tracing,
periodically adjust sensitivity to keep the signal strength near 50. Increase or decrease
sensitivity by pressing + or - on the keypad.
3. For best results while tracing Energized wires, align groove on the Tip Sensor with wire
direction as shown in Figure 3.1e. Signal may be not detected if not properly aligned. To
verify wire direction, periodically rotate the Receiver 90 degrees. Signal strength will be the
highest when wire is aligned with the Tip Sensor groove.
Depending on the detected signal, the Receiver automatically switches to either Energized
De-energized
Note: For best results, keep the Receiver at least 1 meter from the Transmitter and test leads to
minimize signal interference.
mode, and displays this information on the LCD. No manual setup is necessary.
Figure 3.1e: Aligning the Tip Sensor groove
Figure 3.1d: Transmitter indicator
showing signal in HIGH mode
12
Kerbe
or