Contents Of Package; Inserting The Batteries In The Remote Control - Carrera RC 370503016 Instrucciones De Montaje

Instruction Manual

Contents of package

1 1 x Quadrocopter
1 x Controller
1 x USB charging cable
1 x USB adapter
1 x Micro SD-card
1x Rechargeable Battery
2 x Replacement motor (right/left)
1x Screwdriver
2 x 1.5 V Mignon AA batteries
(non-rechargeable)
Recharging the LiPo rechargeable
battery
Make sure you only charge the LiPo rechargea-
ble battery supplied with the LiPo charging unit
also supplied (USB cable and remote control). If
you try to charge the rechargeable battery with
a different LiPo battery charger or any other
battery charger, this might cause serious dam-
age. Please carefully read the previous chap-
ter with warnings and guidelines on the usage
of rechargeable batteries before proceeding.
Supply terminals are not to be short-circuited.
You can charge the rechargeable battery fitted
in the Quadrocopter with its USB charging ca-
ble from a USB port on a computer:
2a Charging via computer:
• Rechargeable batteries are to be removed
from the model before being charged.
• Connect the USB charging cable with the
USB port of a computer. The LED on the USB
charger cable lights green indicating that the
charger unit is correctly connected to the com-
puter. If you plug in a Quadrocopter with a dis-
charged battery, the LED on the USB charg-
ing cable no longer lights up, showing that the
Quadrocopter battery is being charged. The
USB charging cable and the charging socket
on the Quadrocopter are designed to make
incorrect connection impossible.
• It takes about 60 minutes to recharge a
discharged battery (but NOT a deep-dis-
charged one). When the battery is fully
charged, the LED display on the USB
charger cable lights up green again.
Note: when supplied, the lipo-battery is al-
ready partially charged. So the first charg-
ing cycle may well take less time.
It is essential to follow the connection se-
quence given above!
Undo the plugged connection on the
Quadrocopter when you are not using the
Quadrocopter. Failure to observe this pre-
caution may cause battery damage!
Insertion of the rechargeable batteries
2b
into the Quadrocopter
• Insert the battery.
• If the LED on the Quadrocopter flashes
slowly, you must change the battery.
Inserting the batteries in the
remote control
3 Open the battery compartment with a screw-
driver and insert the batteries in the remote
control. Please keep in mind the correct po-
larity. Different types of batteries or new and
used batteries are not to be mixed. After
having closed the compartment you can
check all functions of the remote control with
the help of the power-switch on the front.
With the power switch turned ON and
functioning correctly, the top centre LED
on the remote control will light up red. If
the LED control flashes slowly and an
acoustic signal is heard, the batteries in
the controller must be changed.
Frequency bind between model
and remote control
4 The Carrera RC Quadrocopter and the
controller automatically link up renewed
with every operational start-up. If initially
there are any problems with communica-
tion between the Carrera RC Quadrocop-
ter and the remote control, please carry
out a new frequency bind.
19
ENGLISH