Milwaukee 2792-20 Manual Del Operador página 3

32) ChARgE IN A WELL VENTILATED AREA.
Do not block charger vents. Keep them clear to
allow proper ventilation. Do not allow smoking
or open flames near a charging battery pack.
Vented gases may explode.
33) MAINTAIN ChARgER CORD. When unplug-
ging charger, pull plug rather than cord to
reduce the risk of damage to the electrical plug
and cord. Never carry charger by its cord. Keep
cord from heat, oil and sharp edges. Make
sure cord will not be stepped on, tripped over
or subjected to damage or stress. Do not use
charger with damaged cord or plug. Have a
damaged charger replaced immediately.
34) DO NOT USE AN EXTENSION CORD UN-
LESS IT IS ABSOLUTELy NECESSARy.
Using the wrong, damaged or improperly wired
extension cord could result in the risk of fire and
electrical shock. If an extension cord must be
used, plug the charger into a properly wired 16
gauge or larger extension cord with pins that
are the same number, size and shape as the
pins on the charger. Make sure that the exten-
sion cord is in good electrical condition.
35) USE ONLy RECOMMENDED ATTACh-
MENTS. Use of an attachment not recom-
mended or sold by the battery charger or
battery pack manufacturer may result in a risk
of fire, electric shock or personal injury.
36) UNPLUg ChARgER when not in use. Remove
battery packs from unplugged chargers.
37) TO REDUCE ThE RISK Of ELECTRIC
ShOCK, always unplug charger before clean-
ing or maintenance. Use a Ground Fault Circuit
Interrupter (GFCI) to reduce shock hazards.
38) STORE yOUR BATTERy PACK AND ChAR-
gER in a cool, dry place. Do not store battery
pack where temperatures may exceed 120°F
(50°C) such as in direct sunlight, a vehicle or
metal building during the summer.
federal Communications Commission
WARNINg: Changes or modifications
to this unit not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is en-
couraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV
technician for help.
specificaTions
AC Input
Cat. No. Volts
2792-20 120
* Charges MILWAUKEE M18™ Li-Ion battery
packs 48-11-1815, 48-11-1820, 48-11-1828
and 48-11-1840.
symbology
Volts
Direct Current
Alternating Current
A
Amps
Hertz
Double Insulated
Presence of important operating
instructions.
Caution. Risk of electric shock.
Federal Communications
Commission
Underwriters Laboratories, Inc.
United States and Canada
grounding
Double Insulated Radios:
Radios with Two Prong Plugs
Radios marked "Double Insulated" do not require
grounding. They have a special double insula-
tion system which satisfies OSHA requirements
and complies with the applicable standards of
Underwriters Laboratories,
Inc., the Canadian Stan-
dard Association and the
National Electrical Code.
Double Insulated radios
may be used in either of
the 120 volt outlets shown
in Figures A and B.
3
DC Output *
Amps Volts
2.1 18
fig. A
Amps
3.5
fig. B