Publicidad
Idiomas disponibles
Idiomas disponibles
I n t e n t o f U s e
The collar cropper attachment in combination with the Genesis
®
Maxlok
collars from fasteners from 4.8mm (3/16") to 6.4mm (1/4"). The correct collar cropper kit must be selected for each fastener size
and type as shown in the table on this page.
The tool and collar cropper must be used in accordance with the safety rules and fitting instructions contained within this
datasheet. The cropping of other fastener sizes or materials not included in the table on this page could have a detrimental
impact on the working life of the tool and collar cropper and could invalidate the warranty.
Refer to the assembly drawing in the appropriate tool manual - nG4, G4 or G2LB.
Item numbers in bold refer to the parts listed in the table below.
To prepare base tools to accept Collar Cropper equipment
1
Unscrew Jaw Spreader Housing 71210-02101, (Chuck Collet
Adaptor 07610-00501 for G2LB). Remove Locknut 71210-
02105 and Seal Housing 71210-02104. Remove Vacuum
Sleeve 71230-02102 (applies to nG4 and G4 only).
2
Screw Stop Nut 6 fully onto the Piston by hand. Refit Jaw
Spreader Housing 71210-02101, ((4 and 5) supplied in kit for
G2LB), screw fully onto the Piston before tightening Stop Nut
6 against it.
3
Remove the Stem Collector Bottle Assembly and replace with
Safety Cap 7. For nG4 tools fitted with Quick Release
Collector Bottles remove this and fit Safety Cap 8.
Fitting the Collar Cropper Assembly
1
Screw Collet Adaptor 3 onto Jaw Spreader Housing 4 and 5
and tighten.
2
Screw Anvil Adaptor 2 over the Collet Adaptor 3 into the front
of the tool and tighten.
3
Attach Cropper Assembly 1* by screwing the Cam Rod of the
Assembly onto the Collet Adaptor 3.
4
Complete attachment by screwing the Nose Retaining Nut of
the Collar Cropper 1* assembly onto the Anvil Adaptor 2.
C o l l a r C ro p p e r K i t s
ITEM
71230-20100 3/16 COLLAR CROPPER KIT - AVDELOK
71230-20110
71230-20120
Kits include:
1*
07500-06800
1*
07500-06900
1*
07500-05900
2
07498-05001
3
07498-05002
4
71210-02101
5
07003-00277
6
71233-20300
7
71210-20201
8
71213-20201
9
07900-00828
* Kit includes the specified Collar Cropper Assembly
®
nG4, G4 or G2LB tool is designed for cutting and removing Avdelok
I M P O R T A N T
1/4 COLLAR CROPPER KIT - AVDELOK
1/4 COLLAR CROPPER KIT - MAXLOK
Collar Cropper Assembly 3/16 Avdelok
Collar Cropper Assembly 1/4 Avdelok
Collar Cropper Assembly 1/4 Maxlok
Anvil Adaptor
Collet Adaptor
Jaw Spreader Housing
'O' Ring
Stop Nut Assembly - Collar Cropper
Safety Cap
Safety Cap - Quick Release Bottle
Collar Cropper Data Sheet
7
1
3
4
5
®
®
/ MAXLOK
®
®
®
®
/Maxlok
®
®
®
and
8
2
6
Publicidad
