Using The Remote Control; Remote Control Keys - Sanyo DP26746 Manual Del Propietário

PRECAUTIONS
To ensure safe operation, please observe the following
precautions:
Replace both batteries at the same time. Do not use a new
battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect type.
Do not expose the Remote Control Unit to moisture or heat.

REMOTE CONTROL KEYS

Œ
nput Key—Press to change the input signal
I
source as follows: Analog RF ¬ Digital RF ¬
Video 1 ¬ Video 2 ¬ Video 3 ¬ HDMI ¬
Analog RF .

Number Keys—Two keys must be pressed
to select a direct channel. Example: Press 0
then 6 to select channel 6.
For Analog Cable channels above 100,
press and hold the 1 key until C1– –
appears, then press the other two
numbers.
Ž
Info Key—Press to display the Digital and
Analog Full Banner information (press again
to remove the display).
Digital Full Banner display— Contains a two-
part Channel Number (Major and Minor), and
Tuner ID. If available the following is also
included: Station ID, V-Chip Program Rating,
Program Title, Audio Info, and Signal Strength.
Channel
Tuner ID
Major Minor
Audio Info
Program Title

USING THE REMOTE CONTROL

Program Rating
Station ID
Signal Strength
Need help?
Visit our Web site at
Point toward
DTV
Œ

Ž
Analog Full Banner display— Contains the
Channel Number (analog antenna/cable),
Tuner ID, Station ID (if available), Program
Title (if available), V-Chip Program Rating, and
Audio Info.
Channel No.
Tuner ID
Program Title
Audio Info
www.sanyoctv.com
or Call
Station ID Program Rating
(Continued on page 18.)
17
1-800-877-5032