Chauvin Arnoux C.A 6456 Manual De Instrucciones página 69

4.3.6 WARNINGS OR ERROR REPORTS (EARTH MEASUREMENT IN LIVE CONDITION)
Preliminary remark: The complete list of coded errors is given in § 7.
Affichage - Indication
Hz
U > 25 (ou) 50V
C
Hz
<90 V
Hz
U > 25 (ou) 50V
NPE
< 15.3 Hz (ou) > 65Hz
U (ou) U (ou) U
LN NPE
NO
rOd
Er10
U > 50V (ou) 25V
P
> 15kΩ Ω Ω Ω Ω
R
P
U
P
Er04
U > 50V (ou) 25V
F
Er05
Er06
I = ----
> 80°C
HOt
Press the TEST key to exit from the error conditions.
Commentaire - Cause possible
Voltage > U between the TEST key and PE: the measurement
L
is disabled.
One of the voltages, U
is impossible.
U is AC and > U
NPE
The frequency of U
65 Hz : the measurement is impossible.
LPE
The rod is not connected, the measurement is stopped.
U > U : the measurement is disabled.
P L
Resistance of the auxiliary rod too high: the measurement
is stopped.
Connection of a current probe after selection of measurement
without tripping: the instrument automatically reverts to
measurement with tripping and reports the fact.
During the measurement, U
SET-UP mode: the measurement is stopped.
During a selective measurement, the product of the current
measured by the current probe and the measured voltage is
too low: the measurement is stopped.
During a selective measurement, the current measured by the
current probe is too unstable: the measurement is stopped.
The temperature of the instrument is too high: the masurement
is stopped. Pressing the TEST key has no effect until the
temperature of the instrument is again below 60°C; another
measurement can then be started.
69
or U is < 90 V : the measurement
LN LPE
: the measurement is impossible.
L
, U , or U is < 15,3 Hz or >
LN LPE NPE
exceeds the value set in the
F