DeWalt DWE402 Manual De Instrucciones página 12

4-1/2" (115 mm) Grinding Wheels
Type 27 guard
unthreaded backing flange
Type 27 hubbed wheel
Type 27
depressed center wheel
threaded locking flange
Mounting Guard
CAUTION: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding with
conventional sanding discs. A Type 1 guard (intended for use with Type
1 cutting wheels and Type 27 wheels marked for cutting only) is
available at extra cost from your local dealer or authorized service
center. Grinding with wheels other than Type 27 and Type 29 require
different accessory guards not included with the tool. A type 27 guard
is provided for use with a 1/4" (6.35 mm) thick Type 27 wheel.
Type 27 guard
Type 27 guard
3" (76.2 mm)
wire cup brush
Wire Wheels
Type 27 guard
4" (100 mm) wire wheel
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose; 1/4" (6.35 mm)
thick wheels are designed for surface grinding while thinner Type 27
wheels need to be examined for the manufacturer's label to see if
they can be used for surface grinding or only edge grinding/cutting.
A Type 1 guard must be used for any wheel where surface grinding
is forbidden. Cutting can also be performed by using a Type 1 wheel
and a Type 1 guard.
MOUNTING, ADJUSTING AND REMOVING (TYPE 27)
ONE-TOUCH™ GUARD (FIG. 3)
Your grinder is supplied with a keyless ONE TOUCH™ guard.
1. Press the guard release lever (J).
2. While holding the guard release lever open, align the lugs (L) on
the guard with the slots (M) on the gear case.
3. Keeping the guard release lever open, push the guard down until
the guard lugs engage and rotate them in the groove on the gear
case hub. Release the guard release lever.
10
Sanding Discs
rubber backing pad
sanding disc
clamp nut