Stihl MS 290 Manual De Instrucciones página 22

A
Conventional cut
A = felling notch - determines the
direction of the fall
For a conventional cut:
:
Properly place felling notch
perpendicular to the line of fall,
close to the ground
:
Cut down at app. 45-degree angle
to a depth of about 1/5 to 1/4 of the
trunk diameter
:
Make second cut horizontal
:
Remove resulting 45-degree piece
MS 290, 310, 390
Open-face technique
A = felling notch - determines the
direction of the fall
For an open-face cut:
:
Properly place felling notch
perpendicular to the line of fall,
close to the ground
:
Cut down at app. 50-degree angle
to a depth of app.1/5 to 1/4 of the
trunk diameter
:
Make second cut from below at app.
40 degree angle
:
Remove resulting 90-degree piece
English / USA
Making sapwood cuts
:
For medium sized or larger trees
make cuts at both sides of the trunk,
:
at same height as subsequent
felling cut.
:
Cut to no more than width of guide
bar.
This is especially important in
softwood in summer - it helps
prevent sapwood splintering when
the tree falls.
21