Listening To Fm And Am Broadcasts; Setting The Tuner Interval Spacing; Tuning In To A Station - JVC UX-H10 Manual De Instrucciones

Listening to FM and AM Broadcasts

Setting the Tuner Interval Spacing

You can select 10 kHz or 9 kHz apart for the AM tuner
interval spacing and 100 kHz or 50 kHz apart for the FM
tuner interval spacing.
• You need to do this setting separately for each band.
On the unit ONLY:
1
Press TUNER/BAND to select either
"FM" or "AM."
The unit automatically turns on and tunes in to
the previously received station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
2
Press STANDBY/ON
while holding down 7.
• Each time you press
STANDBY/ON, the interval
spacing alternates as follows:
While selecting the AM tuner
10K (10 kHz) Ô 9K (9 kHz)
While selecting the FM tuner
100K (100 kHz) Ô 50K (50 kHz)
When you change the setting
The preset stations are erased. You will need to preset the stations
again. (See page 11.)

Tuning in to a Station

1
Press TUNER/BAND to select either
"FM" or "AM."
The unit automatically turns on and tunes in to
the previously received station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
TUNER
/BAND
2
Press and hold ¢ or 4
(or ¡/¢ or 4/1 on
the unit) for more than 1
second.
• ¢ (¡/¢):
CD
CONTROL
• 4 (4/1):
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
STANDBY/ON
• If an FM program is broadcast in stereo, the ST (stereo)
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or ¡/¢ or
4/1 on the unit).
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive
or noisy, press REPEAT ST/MONO so that the
MONO indicator lights up on the display.
Reception will improve.
To restore the stereo effect, press REPEAT ST/MONO
again so that the MONO indicator goes off. In stereo mode,
you can hear stereo sound when a stereo program is
broadcast.
To reduce the beat—Beat Cut
On the remote control ONLY:
If the beats are heard while listening a
broadcast, press BEAT CUT.
Increases the frequencies.
Decreases the frequencies.
When you repeatedly press ¢ or 4 (or ¡/¢ or
4/1 on the unit)
TUNER
/BAND
REPEAT
ST/MONO
BEAT CUT
10