Common Operations; Setting The Clock; Turning On The Power; Turning Off The Unit Automatically (Auto Standby) - JVC UX-G4 Manual De Instrucciones

Common Operations

Setting the Clock

Before operating the unit any further, first set the unit's clock.
When you plug in the power cord, "0:00" starts flashing on
the display.
You can set the clock when the unit is either turned on or in
standby mode.
On the remote control ONLY:
1
Press CLOCK/TIMER.
The hour indication starts flashing.
2
Press UP or DOWN to adjust
the hour, then press SET.
• When you press and hold UP or
DOWN, the hour indication changes
continuously.
The minute indication starts flashing.
• The clock is working even while setting.
3
Press UP or DOWN to adjust
the minute, then press SET.
• When you press and hold UP or
DOWN, the minute indication
changes continuously.
The built-in clock starts.
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to "0:00." If this happens, set the clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
9
To adjust the clock
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly
to show the current time indication.
The hour indication starts flashing.
2
Repeat steps 2 and 3 on the left column.
CLOCK
/TIMER

Turning On the Power

To turn on the unit, press STANDBY/ON
The STANDBY lamp on the unit goes off.
• When you press the source button—CD 3/8,
TAPE 2 3, FM/AM and AUX, the unit
automatically turns on.
UP
PRESET
GROUP
To turn off the unit (standby), press STANDBY/ON
DOWN
PRESET
again.
GROUP
The STANDBY lamp on the unit lights red.
• "0:00" flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is in standby mode.
SET
• A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
UP
PRESET
GROUP
Turning Off the Unit Automatically
DOWN
PRESET
GROUP
(Auto Standby)
Using Auto Standby, the unit automatically turns itself off (on
standby) about 3 minutes after playing back a disc or a tape.
SET
• You can also turn off the unit automatically by using the
Sleep Timer. (See page 22.)
On the remote control ONLY:
To activate Auto Standby, press A.STANDBY.
The A.STANDBY indicator appears on the
display.
• When the playback is stopped, the
A.STANDBY indicator starts flashing on the
display.
To deactivate Auto Standby, press A.STANDBY again.
The A.STANDBY indicator goes off.
CLOCK
/TIMER
.
STANDBY/ON
A. STANDBY