Tyco Healthcare Puritan Bennett GoodKnight 425 Manual De Uso página 17

In this case, one of the following two screens indicates the status of your equipment (the values
displayed are given as a guide only).
The two points are blinking.
The device is on standby.
NOTE
Exit from the parameter setting menu takes place automatically when you do not press any key for
30 seconds.
Adjustment of the pressure at the device outlet
Connect the spiral hose to the device and the small hose that emerges through the spiral hose to the
pressure point. Connect the hose's free nozzle to a plug equipped with a 4 mm leak and a pressure
point. Turn the device blower on, then connect the pressure point to a manometer and adjust the
pressure order to 14 cmH
titled « Settings » of this manual. Adjust the value by using the on/off (up)
key in order to read a pressure equal to 14,0 cmH
maintaining the pressure on the hidden key, press the information access
sensor offset setting is automatically memorized.
Change of unit of pressures displayed
The unit of the pressures displayed may be changed between cmH
To change it, press and hold the hidden key while you connect the device to the electrical outlet (by
the power supply module). The machine displays the new unit selected until you release the
pressure on the hidden key. To change again the unit displayed, repeat the process.
GoodKnight 425 / GoodKnight 425 ST
9:34
¹
Compliance operation indicator
- 1 : compliance on
- 0 : compliance off
O. Access to the pressure sensor offset setting as described in the section
2
9.0
1
Indicator of patient respiratory cycle
detection (on the GK425ST only)
The device is running.
O on the manometer. Then, while
2
O and hPa, and conversely.
2
cmH O
2
:
Indication of the
Positive Inspiratory Pressure IPAP
Positive Expiratoire Pressure EPAP
or ramp (down)
key. The pressure
EN – 9