Declaration Of Conformity - Roland V-1HD Manual De Usuario

IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.
BLUE:
BROWN:
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.
Model Name :
V-1HD
Type of Equipment :
HD VIDEO SWITCHER
Responsible Party :
Roland Corporation U.S.
Address :
5100 S. Eastern Avenue Los Angeles, CA 90040-2938
Telephone : (323) 890-3700
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment requires shielded interface cables in order to meet FCC class B limit.
Any unauthorized changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to
operate the equipment.
CAN ICES-3 (B)/NMB-3 (B)
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
NEUTRAL
LIVE

DECLARATION OF CONFORMITY

Compliance Information Statement
FEDERAL COMMUNICATIONS COMMISSION
WARNING
For the U.K.
For the USA
For the USA
For Canada
For Korea
For C.A. US (Proposition 65)
41