Driving Forward Or Backward; Stopping The Machine; Adjusting The Height Of Cut - Toro Timecutter Z4200 Manual Del Operador

Ocultar thumbs Ver también para Timecutter Z4200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Driving Forward or Backward
The throttle
control
regulates
the engine
speed
as
measured
in rpm
(revolutions
per minute).
Place
the throttle
control
in the Fast position
for best
performance.
Ahvays
operate
in the fL_ throttle
position.
To turn, release pressure
on the motion
control
lever
toward
the direction
you want to turn (Figure
15).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
The
machine
can
spin
very rapidly.
The
operator
may
lose
control
of the machine
and cause
personal
injury
or damage
to the
machine.
Use caution
when making
turns.
Slow the machine
down before making
sharp turns.
Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion control
levers forward (Figure 15).
1
2
2
1
/
3
Figure 15
1.
Park (brake) position
3.
Forward
2.
Center unlock position
4.
Backward
4
G004532
Backward
,
2.
Move the levers to the center, unlocked
position.
To go backward, slowly pull the motion control
levers rearward (Figure 15).
To go straight, apply equal pressure to both motion
control levers (Figure 15).
To turn, release
the pressure
on the motion
control
lever toward
the direction
you want to turn
(Figure
15).
To stop, push the motion
control
levers to neutral.
Stopping the Machine
To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
Children
or bystanders
may
be injured
if they
move
or attempt
to operate
the mower
while
it
is unattended.
Always
remove
the ignition
key and move
the
motion
control
levers
outward
to the park
position
when
leaving
the machine
unattended,
even if just for a few minutes.
Adjusting the Height of Cut
1. Raise the height-of-cut
lever to the transport
position, cutting height position 4.5 (also the
4-1/2 inch [115 mm]) (Figure 16).
To go straight, apply equal pressure to both motion
control levers (Figure 15).
18

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

74360

Tabla de contenido