Installing The Battery; Servicing The Fuses - Toro Timecutter Z4200 Manual Del Operador

Ocultar thumbs Ver también para Timecutter Z4200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Incorrect
battery
cable
routing
could
damage
the machine
and cables
causing
sparks.
Sparks
can
cause
the battery
gasses
to explode,
resulting
in personal
injury.
Always
disconnect
the negative
(black)
battery
cable
before
disconnecting
the
positive
(red)
cable.
Always
connect
the positive
(red)
battery
cable
before
connecting
the negative
(black)
cable.
5. Slide the rubber cover up the positive (red) cable.
Disconnect
the positive (red) cable from the battery
post (Figure 32). Retain all fasteners.
6. Remove the battery hold-down
(Figure 32) and lift
the battery from the battery tray.
2
6
5
1
4
G005072
I
Figure
32
1.
Battery
5.
Negative battery post
2.
Positive battery post
6.
Wing nut, washer, and bolt
3.
Bolt, washer, and nut
7.
Battery hold-down
4.
Terminal boot
Charging
the Battery
Service
Interval:
Before
storage--Charge
the battery
and disconnect
battery
cables.
1. Remove
the battery
from
the chassis;
refer to
Removing
the Batter 7
2.
Charge
the battery
for a minimum
of I hour at 6 to
10 amps. Do not overcharge
the batter>
3.
When
the battery
is fully charged,
unplug
the charger
from the electrical
outlet,
then disconnect
the
charger
leads from the battery
posts
(Figure
33).
4
2
3
1
G000538
Figure 33
1.
Positive battery post
3.
Red (+) charger lead
2.
Negative battery post
4.
Black (-) charger lead
Note:
Do not run the machine with the battery
disconnected,
electrical damage may occur.
Installing the Battery
1. Position the battery in the tray with the terminal
posts toward the operating position (Figure 32).
2. Install the positive (red) battery cable to the positive
(+) battery terminal using the fasteners removed
previously.
3. Install the negative battery cable to the negative
(-) battery terminal using the fasteners removed
previousl)_
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down
(Figure 32).
6. Install
the left side console.
Refer to the Accessing
the Battery
procedure
in Premaintenance
Procedures
, page 23 for instructions.
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance;
however, if a fuse blows, check the
component/circuit
for a malfunction
or short.
Fuse:
Main FI-30 amp, blade-_pe
Charge Circuit F2-25 amp, blade-type
1. Raise the seat to gain access to the fuse holder
(Figure 34).
2. To replace a fuse, pull out on the fuse to remove it
(Figure 34).
30

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

74360

Tabla de contenido