Basic Parameters; Set Pressure Quick Adjustment - DGFLOW STEADYPRES M/M 8.5 Manual De Uso Y Mantenimiento

The basic parameters for the configuration of the inverter must necessarily be set during installation
BASIC P 3.5
2P 2.5
A 6.0
RO
To increase 0,1 bar press
SIMULTANEOUSLY
To decrease 0,1 bar press
SIMULTANEOUSLY
To display the FW version of the
CONTROL BOARD (FWI) and the
POWER BOARD (FWP)

BASIC PARAMETERS

Sets the constant
working pressure in the
system.
Sets a second working
pressure. To activate
configure parameter EI in
ADV. parameters.
Sets the motor rated current at the inverter output (rated
current of the motor)
At low supply voltages, the current set should leave a margin
(eg. + 15%) to compensate for the low voltage.
ONLY FOR THREE-PHASE OUTPUT - Set the direction
of rotation of the three-phase motor (CW / CCW)

Set pressure quick adjustment

display the firmware version (FW)
ENTER
P_3.2
ENTER
Bring
STEADYPRES out
of service (OFF)
P_3.3
P_3.1
Press
simultaneously