Presentation; Standard Models In A A100 Series; Custom Models - Chauvin Arnoux AmpFlex A100 Manual De Instrucciones

1.1. STANDARD MODELS IN A A100 SERIES

A100 Series AmpFlex® sensors make up a range of nine standard models which enable the measurement
of alternating current from 0.5 A to 10 kA at industrial frequencies. Each probe is of a flexible air-core
type (45 cm, 80 cm or 120 cm) attached by a shielded cable to a small box housing the integrator circuit
and a standard 9 V battery.
Their flexibility means that they can be attached to any type of conductor for measurement (including
cables, busbars and stranded conductors), regardless of its accessibility. Because of the latch-type design
of the air-core's open/close mechanism, it is appropriate to use gloves when operating it.
The box is fitted with a two-position switch (single range) or a three-position switch (dual range) and two
LED diodes. One indicates that the device is in use (green LED), and the other warns when the integrator
circuit is overloaded (red LED).
Probes can be connected to any multimeter, tester, recorder, etc. fitted with an alternating voltage input
with an impedance over 1 MW (AC mode without a DC component). They have reinforced insulation and
comply with international standards, particularly IEC 61010-1.
2 kA
2 kA
20 A / 200 A
200 A / 2 kA
200 A / 2 kA
300 A / 3 kA
300 A / 3 kA
300 A / 3 kA
1 kA / 10 kA

1.2. CUSTOM MODELS

Probes of different length or sensitivity (mV/A) are available upon request. Custom lengths can be supplied
in 10 cm increments: contact us for more information.

1. PRESENTATION

9 standard models
Range
single range
single range
dual range
dual range
dual range
dual range
dual range
dual range
dual range
* 45 cm air core are preshaped.
13
Lenght*
45 cm
80 cm
45 cm
45 cm
80 cm
45 cm
80 cm
1.20 m
1.20 m