Mains Connection - Gude GEH 3300 F Traducción Del Manual Original

ENGLISH
20
Switch off the apparatus, discon-
nect it from mains by unplugging
and allow it to cool down before
setting up, retrofitting, cleaning,
performing maintenance, storing
or transporting the apparatus.
Switch off the device and discon-
nect it from the power supply
before replacing accessory parts,
cleaning work and if it is not in
use. Do not put foreign objects in
the device.

Mains Connection

Operation is only allowed with a safety switch
against stray current (RCD max. stray current of
30mA).
Not suitable for installation on fixed electrical cables.
Only operate the heater when the mains cable is fully
rolled out.
SYMBOLS
Read the operating instructions to reduce
the risk of injury.
Unplug the machine before any work
on it.
Warning / Caution
Warning against hot surfaces!
Danger of burns!
Keep distance of persons
Observe to keep out of dangerous zone
Caution! Danger: high voltage
Keep dry at all times. Never expose tool
to rain.
Warning: To prevent overheating, never
cover the heater with anything.
European Conformity Mark
Weight
Rated input
Rated voltage
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
Operation
After you have read and understood the safety
instructions, you may commission the device.
Place the electric heater in the centre of the room if
possible, or at least 1 metres away from the wall to
achieve optimum heat distribution. The air circulates
better as a result, and the room warms up more quic-
kly. All windows and doors should remain closed.
1) Put the mains cable into a suitable socket. Make
sure that your mains network is appropriately
fused.
2) Set the desired power with the power setting
controller.
3) To switch off the electric heater, set the power
setting controller to the fan position for 3–5
minutes. The device can then be switched off or
unplugged.
4) After switching off the device, the fuel rods
continue to emit heat. Let the device cool down
before storing it.
An unpleasant smell may be produced when the
device is used for the first time in some cases. This
is however completely harmless and will disappear
completely over time
MAINTENANCE
Unplug the machine before any work on it.
Repairs and works specified in these Instructions may
only be performed by qualified authorised staff.
Use only original accessories and original spare parts.
Always keep the device clean, as well as the venti-
lation slots in particular. Never spray water on the
device body!