High Pressure; Low Pressure - Power Stroke PS14120 Manual Del Operador

USING THE TRIGGER AND LOCK-OUT
See Figure 10.
For greater control and safety, keep both hands on the
trigger handle at all times.
 Pull back and hold the trigger to operate the pressure
washer.
 Release the trigger to stop the flow of water through the
nozzle.
To engage the lock-out:
 Push up on the lock-out until it clicks into the slot.
To disengage the lock-out:
 Push the lock-out down and into its original position.
To use the spray wand, start with the nozzle 1-2 ft. away
from the cleaning surface. Carefully approach the surface
just until the desired level of cleaning is achieved. If the spray
is too close it can damage the cleaning surface.
SELECTING THE RIGHT NOZZLE FOR THE JOB
See Figure 11.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the Nozzle Selection Guide for more informa-
tion about which nozzle to choose.
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
OPERATION
NOZZLE SELECTION GUIDE
(NO SOAP WHEN USING THESE NOZZLES)
 Recommended Nozzle
Page 13 — English
WARNING:
NEVER remove nozzles without first turning off the mo-
tor, relieving the water pressure in the trigger handle, and
locking the lock out on the trigger handle. NEVER point
the nozzle at your face or at others. The quick-connect
feature contains small springs that could eject the nozzle
with some force. Failure to follow these instructions could
result in an eye injury or other serious personal injury.
To connect a nozzle to the spray wand:
 Turn off the pressure washer and shut off the water sup-
ply. Pull trigger to release water pressure.
 Engage the lock-out on the trigger handle .
 Pull back the quick-connect collar.
 Push the nozzle into place in the spray wand.
 Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
To disconnect a nozzle from the spray wand once the
cleaning job is complete:
 Turn off the pressure washer and shut off the water sup-
ply. Pull trigger to release water pressure.

HIGH PRESSURE

Turbo Nozzle




Use With Caution for Certain Applications


LOW PRESSURE

(FOR SOAP OR
GENTLE RINSE)
Blue or Black
15º
Soap Nozzle
 
 
 
 