Manual Mode - schmalz SCPi Instrucciones De Servicio

Manual mode

The output signals may change during set-up in manual mode.
Ensure that the machine or system does not start moving as a result.
Personal injury or damage to the ejector could occur as a result.
Manual mode can be used for locating and eliminating leakage.The ejector can be con-
trolled manually using the buttons on the membrane keypad. In this operating mode, the
H1 and H2 LEDs both flash.
A
CTIVATING MANUAL MODE
Activate manual mode as follows:
 Press and hold the

Manual mode can be used even if actuator voltage is not present (emergency
stop, setup mode).
M
ANUAL SUCTION
The suction mode is activated in manual mode by pressing the
mode is exited by pressing the
This is also active in manual mode when the air-saving function is activated

[ctr=on]
Instead off the Error code

The valve protection function is not active in manual mode.
M -
ANUAL BLOW OFF
The blow-off mode is activated in manual mode by pressing the
remains active as long as the button is pressed.

If actuator voltage is not present, manual blow-off mode is not available. Error
[E05]
code
S
C H MA LZ
and
button again or by pressing the
(RD ejectors). This applies even if actuator voltage is not present.
[E05]
is displayed.
SCP / SMP
I I
buttons together for more than 3 seconds.
the actual vaccum value is shown.
GB - 7
button. The suction
button.
button. The mode