Replacing The Spark Arrestor; Replacing The Spark Plug - Toro 51958 Manual Del Operador

Replacing the Spark Arrestor

See Figure 17.
WARNING:
personal injuries.
NOTICE:
product users must comply with Federal, State,
with appropriate authorities. Contact customer
a replacement spark arrestor.
Note: Depending on the type of fuel used, the type and
loss with your gas powered tool, you may need to remove
these deposits to restore performance. We highly recom-
service.
repeated use. If replacement is necessary, use Toro part
To replace the spark arrestor:
1.
Note:
Cover
Screw(s)
Spark
Arrestor
Muffler
Plate
Gasket
Muffler
20
Muffler
Cover
Screw(s)
Screw(s)
Figure 17
2. Remove the cover.
3.
place.
4.
5.
6. Remove the three screws that hold the plates on the
7. Remove the spark arrestor.
8. Replace the old spark arrestor with the new one.
9.
10.
11.
12.
Note: Do not over-tighten screws.

Replacing the Spark Plug

See Figure 18.
or equivalent replacement and replace annually.
1.
2.
with a socket.
3. Remove the spark plug.
4.
properly gapped and free of deposits in order to ensure
proper engine operation. The correct gap is approxi-
gap, gently tap ground electrode on a hard surface.
Spark Plug Boot
Spark
Plug
Figure 18
Operation